The interest in the application of carbon nanotube (CNT) composites is recently increasing in several industrial sectors. The main reason for this growing attention is the reinforcing effect of the CNTs. However, the composite use is limited by technological issues concerning the manufacturing processes when small features are required. A multistage process chain could exploit the advantages of suitable processes to enhance the control of the filler orientation. This paper investigates the feasibility of milling micro features on micro injected specimens of POM/CNT and LCP/CNT composites. Design of experiment is used to study a suitable experimental design to investigate the influence of the material and the process parameters on the machinability and the feature geometry. POM-based composites showed a better machinability and allowed a fabrication of more accurate features, while LCP showed high cutting forces and the presence of diffused burrs, preventing the fabrication of very small features.

Micro milling of polymeric micro injected specimens with randomly oriented carbon nanotube fillers

Attanasio A.;Ceretti E.;Fassi I.
2020-01-01

Abstract

The interest in the application of carbon nanotube (CNT) composites is recently increasing in several industrial sectors. The main reason for this growing attention is the reinforcing effect of the CNTs. However, the composite use is limited by technological issues concerning the manufacturing processes when small features are required. A multistage process chain could exploit the advantages of suitable processes to enhance the control of the filler orientation. This paper investigates the feasibility of milling micro features on micro injected specimens of POM/CNT and LCP/CNT composites. Design of experiment is used to study a suitable experimental design to investigate the influence of the material and the process parameters on the machinability and the feature geometry. POM-based composites showed a better machinability and allowed a fabrication of more accurate features, while LCP showed high cutting forces and the presence of diffused burrs, preventing the fabrication of very small features.
File in questo prodotto:
File Dimensione Formato  
IJMMM220206_234586.pdf

Open Access dal 06/04/2023

Descrizione: Paper
Tipologia: Full Text
Licenza: NON PUBBLICO - Accesso privato/ristretto
Dimensione 1.68 MB
Formato Adobe PDF
1.68 MB Adobe PDF Visualizza/Apri

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/11379/528875
 Attenzione

Attenzione! I dati visualizzati non sono stati sottoposti a validazione da parte dell'ateneo

Citazioni
  • ???jsp.display-item.citation.pmc??? ND
  • Scopus 1
  • ???jsp.display-item.citation.isi??? ND
social impact